The heart of your fabrication shop! Versatile 3/4 HP hydraulic ironworker punches and shears. Works in virtually any shop on a dedicated 110 Volt circuit with a 20 Amp breaker. A valuable part of any industrial, home or farm fabrication shop, this ironworker will increase productivity and profitability with quick, accurate fabrication capabilities. Large 16in. L x 11in. W power cavity handles 20 tons centered; 40 tons at the punch. Has 3 3/4in. throat depth. Punches at 6 strokes per minute. Punch capacity is 1in. diameter in 3/8in. steel. Punch ram and retaining nut are heat treated and ground for long life. The 3-in-1 shear handles flat bar measuring 3/8in. x 4in. to 1/4in. x 6in., round to 1/4in. and square to 5/8in. thick. Also does shearing on angle iron to 1/4in. x 3in. x 3in., all in one quick setup. All wear parts and blades are made from high grade tool steel, heat treated and ground. Die holder, stripper and punch retaining nut are included, punches and dies are sold separately, below. 1 gallon oil capacity. Overall size: 30in. L x 24in. W x 55 1/4in. H. U.S.A. Ships truck only.